Go Down

Topic: SIM300 GSM/GPRS module interface to Arduino Uno (Read 6 times) previous topic - next topic

anilmaddala

Hi,

I have a SIM300 GSM/GPRS module and i made the following steps to interface with Arduino UNO:
1) Connect TX pin of SIM300 to PIN6 on Arduino
2) Connect RX pin of SIM300 to PIN7 on Arduino
3) Connect Ground of Arduino with Ground of Sim300.

I am using the following code where NewSoftSerial.h is replaced by SoftwareSerial.h:
http://ks-gsm.svn.sourceforge.net/viewvc/ks-gsm/ksgsm.pde?revision=3

Below is the datasheet of SIM300:
http://www.google.co.in/url?sa=t&rct=j&q=sim300&source=web&cd=1&ved=0CDAQFjAA&url=http%3A%2F%2Frobokits.co.in%2Fdatasheets%2FSIM300_HD_V1.06.pdf&ei=ijxRT6yrBNDrrQfXu7y-DQ&usg=AFQjCNGE_5biYZtm2qmDNg8Qq7xaehSA0Q

Nothing is happening when i send AT command from Arduino, please guide me on what needs to be done.

Thanks,
Anil

PaulS

This section of the forum is for discussing NEW hardware development. It does not sound like you are creating new hardware. So, this post does not belong here. You'll get more answers posting in the right place.

anilmaddala

Hi Paul,

I searched the Forum again, but did'nt find the apt place to post this question.

Can you post a link or path where this question belongs?

Thanks.

PaulS

This belongs in "Networking, Protocols, and Devices".

Abishai

Nice, you can also find some useful stuff at the following site:

http://abishaisingh.wordpress.com/2012/06/03/gsm-modem-sim-300-sending-text-sms-arduino/

Must watch.....its nice

Go Up
 

Quick Reply

With Quick-Reply you can write a post when viewing a topic without loading a new page. You can still use bulletin board code and smileys as you would in a normal post.

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.
Name:
Email:

shortcuts: alt+s submit/post or alt+p preview