Go Down

Topic: Correct way to wire up 9V >> Arduino >> 5V OUT (Read 896 times) previous topic - next topic

scottmcleod

What's the correct way to wire up a 9v circuit IN to the Arduino mini to power it, and a 5v circuit out to power sensors, accessories, etc...?
-Scott

scottmcleod

#1
Jan 27, 2007, 02:18 am Last Edit: Jan 27, 2007, 02:18 am by scottmcleod Reason: 1
NVM. Found it. +9v to Pin 20, -ve to Pin 19. +5v comes from Pin 17, and the ground for the 5v line comes from Pin 3.

PROBLEM:

Why won't the USB work?
-Scott

scottmcleod

USB works, only if you connect the USB power as well. Weird?
-Scott

mellis

The FTDI chip that handles the USB communication (and the USB to serial conversion) is powered by the USB connection.  I guess the assumption is that if there's no USB connection, you don't need any USB communication.  Is there a situtation in which you'd want to communicate over the USB connection without supplying power over the USB connection?

admin

Exactly :)

in the usb world there are 2 category of devices: bus powered and self powered

when arduino is plugged in is bus powered while when you plug the power supply and move sv1 only the ftdi chip is bus powered and the load is quite small (a few ma)

there is only one case where this can be annoying: when the ftdi reports a power need of say 100ma but it needs only 10 (because the FTDI chip is the only one powered) on certain machines the OS might say "sorry i cant accomodate that because there is too much power already used on the bus"

it's a remote event that can be fixed using an active usb HUB...

massimo

Go Up