Loading...
« previous topic   next topic »
Pages: [1]   Go Down
Author Topic: interfacing to 3.3v NAND flash  (Read 304 times)
0 Members and 1 Guest are viewing this topic.
pio
0
Offline Offline
Newbie
*
Karma: 0
Posts: 1
View Profile
« on: February 02, 2007, 02:12:59 pm »
 Bigger Bigger Smaller Smaller Reset Reset
Hello, I'm a new user ... first post

I am underway with a data recovery project.  My data to extract is residing in 3.3v NAND flash.  Since I don't have any expensive NAND programmer or reader, I would like to use Arduino USB to read this device slowly for complete image dump.  I have experience with writing low-level software to do this.

My question is to interface Arduino with my 3.3v Samsung K9F1G08U0A NAND flash, is it a simple matter to replace the Atmega8 part with low-voltage version Atmega8L ?

Thx,
pio
Logged

Pages: [1]   Go Up
Print
« previous topic   next topic »
 
Jump to: