Go Down

Topic: Xbee and IMU wiring (Read 757 times) previous topic - next topic


Hi all,

So here is the thing, the aim is to send data wirelessly between two XBee units.  The Xbee unit sending data receives its voltage supply via the IMU, voltage in 3.3v and out 2.7v (it should be 3.3v).  The affect of the voltage drop means the Xbee is not working to its full potential ...

I'm looking at this thinking it would be better to power each unit separately, but I am concerned that this will result in a voltage over-supply.

How should I be thinking about this?

Thanks again!


We can't guess what is happening without more information - what IMU?  Is it meant to be providing 2.7V or is that the problem (perhaps it is overloading the PSU?)  Which XBee (how much current does it need) and how is it wired?
[ I will NOT respond to personal messages, I WILL delete them, use the forum please ]

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131