Go Down

Topic: Interfacing with CS5460! (Read 1 time) previous topic - next topic

Roevhat

Hello fellow Arduinians,

A friend of mine gave me a power-meassurement device that he would like to see, if I could interface with. The device uses the CS5460 chip. The problem for me however, is that I have no basic knowledge of SPI, and therefor I don't really know where to get started. I used SPI for a LED Matrix Display once, but that was well-documented for use with Arduino -> This is not! I read through the datasheet for the CS5460, but with no good knowledge of how to use SPI - setting it up, what and when to send/receive, and even differentiating between sending and receiving - I could use a helping hand!
I have succesfully connected the correct pins, that I am certain of. But then what? :)

/Roevhat

robtillaart


SPI is just a serial interface in the end. Read - http://arduino.cc/en/Reference/SPI  -

Rob Tillaart

Nederlandse sectie - http://arduino.cc/forum/index.php/board,77.0.html -
(Please do not PM for private consultancy)

Roevhat

I am aware of that. I just can't figure out how to receive data from the CS5460 using SPI : /

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy