Go Down

Topic: receiving i2c commands (Read 544 times) previous topic - next topic


Hi There,

I'm relatively new to i2c, but this is what I want to try and do:

I've got a little controller that I can program to send i2c commands. What I want to do is to connect my arduino board to the controller and receive those i2c commands. How would I connect it to my arduino? I've got three pins for i2c communication SCL_5v and SDA_5v and GND. If I can get it connected are there easy commands to read this i2c input ? Any help would be greatly appreciated and I'll make everything I get to work freely available on the net :)



Check out the Wire library linked to from the library reference page: http://www.arduino.cc/en/Reference/Libraries


thanks for the info. thats exactly what I was looking for.  :)

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131