Pages: 1 [2]   Go Down
Author Topic: not in sync help-UNO board  (Read 1451 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 13
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

without arduino connected, com1, 3, 4 are present along with an lpt3 unusable parallel port
http://screencast.com/t/8SPvWbsM9SnX

with arduino without jumpers connected no change
http://screencast.com/t/zwiVoo8ezN
Logged

Global Moderator
Dallas
Offline Offline
Shannon Member
*****
Karma: 209
Posts: 13022
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset


I must have worded the questions poorly.  I'll try this wording...

• Disconnect the Arduino from the computer

• Remove the jumpers

• Open Device Manager. 
→ Are COM1, COM3, and COM4 listed under Ports? 
→ Are any Unknown devices present anywhere in the tree?

• Connect the Arduino. 
→ Did the computer chime?
→ Are COM1, COM3, and COM4 listed under Ports? 
→ Are any Unknown devices present anywhere in the tree?
Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 13
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

there is an unknown device under other devices tab but nothing under the ports and coms tab
Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 13
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

i loaded the driver to that port it now shows as com5 under coms and ports i run the serial monitor and it echoes what i type i try to upload the revised blink file (made the light blink on for longer and off for shorter) and get the new sync error

avrdude: stk500_getsync(): not in sync: resp=0x30

atleast something is different!
Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 13
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

i would also recommend taking all jumpers off the board before trying to upload!  works great now.  Thank you for all your help.  I was getting frustrated!
Logged

Pages: 1 [2]   Go Up
Jump to: