Pages: 1 2 3 [4]   Go Down
Author Topic: Simple Volume Control  (Read 5226 times)
0 Members and 1 Guest are viewing this topic.
Manchester (England England)
Offline Offline
Brattain Member
*****
Karma: 634
Posts: 34535
Solder is electric glue
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Quote
CAn I make any harm in my arduino?
IF you don't wire it up right you can.

How can I tell if you have wired it up if you don't post a photo?

Quote
the IC is hot and doesnt work
What IC is this then, one in the arduino or the digital pot?
Logged

Offline Offline
Jr. Member
**
Karma: 0
Posts: 57
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

My digital pot is fire hot.

I dind't do anything just cut off the vss line from the gnd and solder the 220V-USB converter between the two wire. The +5 went the gnd and the supply gnd to vss pin.
Logged

Offline Offline
Jr. Member
**
Karma: 0
Posts: 57
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

What happens if I swap the gnd with the +5V? Is it any way to life up this Sigital pot?
Logged

Manchester (England England)
Offline Offline
Brattain Member
*****
Karma: 634
Posts: 34535
Solder is electric glue
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

What part of:-
Quote
How can I tell if you have wired it up if you don't post a photo?
Do you not understand.

Quote
What happens if I swap the gnd with the +5V?
Your chip will get very hot and probably burn!
Logged

Pages: 1 2 3 [4]   Go Up
Jump to: