Hi,This is a general question about servo's - I hope no one minds me asking it here!Is there a way to make the servo idle in a particular position?If I move it to a position and then set the pulse to 0 or off it is slow to respond when I then send it a pwm position. It's really to stop it drawing current and making a noise while holding it's position.Do servo's have a specific PWM for idle? If so I can't find any info on data sheets.Thanks in advance for any info.
There is no reason to 'detach' the servo, in fact the detach command is more often used in error then for any valid reason.
But, OP says that they are noisy when holding still (hard to believe) and consume current (easy to believe). So detaching and powering off would address both of those issues.
Do servo's have a specific PWM for idle? If so I can't find any info on data sheets.
Please enter a valid email to subscribe
We need to confirm your email address.
To complete the subscription, please click the link in the
email we just sent you.
Thank you for subscribing!
via Egeo 16