Pages: [1]   Go Down
Author Topic: Interfacing with a 5-wire glass touch screen  (Read 675 times)
0 Members and 1 Guest are viewing this topic.
0
Offline Offline
Newbie
*
Karma: 0
Posts: 17
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Good morning,

I recently snagged the following touch screen from a surplus electronics shop.  With 5 wires I figured it shouldn't be too difficult to interface with an Arduino.  Does anyone have any insight to how I should be monitoring these wires to figure out how exactly the interface works and how I could determine X/Y cords to where it's being touched?

The surplus shop had literally dozens of these still wrapped in packing paper.  If they're able to be easily interfaced I might just snag them all and sell to other hobbyists on eBay or by some other means.

Details:
Microtouch R2.0
209A-93-A2293R
13-4261-00-01

Wire colors:
Orange, White, Green, Yellow, Black




Find higher res shots here...
http://www.flickr.com/photos/mdweezer/1287759205/
http://www.flickr.com/photos/mdweezer/1287757297/
Logged

0
Offline Offline
Full Member
***
Karma: 0
Posts: 183
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Check this thread and follow the link in the last reply.
Logged

Pages: [1]   Go Up
Jump to: