Go Down

Topic: Nano v.3 suddenly stopped working (programmer is not responding) (Read 559 times) previous topic - next topic

paarsec

Apr 24, 2012, 06:02 pm Last Edit: Apr 24, 2012, 06:22 pm by paarsec Reason: 1
I just got my Arduino Nano v.3 today, which is my first Arduino. I started making simple LED blinking programs just to test it out and everything was working great, i made some small change (i think i changed the delay time of the blinking) and suddenly i couldn't upload to it. I get the following error message:
Code: [Select]
avrdude: stk500_recv(): programmer is not responding
The Nano is still working when i plug it in, i can see my code running. It also shows up on my iMac so it is connected, just as it was earlier when it was working. What could be wrong?

Also, and this might be a stupid question but i'm going to ask it anyways, is it possible to upload code that will ruin the device?

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy