Pages: [1]   Go Down
Author Topic: Phi-connect arduino breadboarding/project box cable management shield  (Read 1333 times)
0 Members and 1 Guest are viewing this topic.
Central MN, USA
Offline Offline
Tesla Member
***
Karma: 73
Posts: 7189
Phi_prompt, phi_interfaces, phi-2 shields, phi-panels
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

FYI, the phi-connect is a shield that passes all arduino UNO pins to a breadboard or a project box so you don't have to curse every time you reconnect say a glcd with 20 wires. You make the connections once and leave them with the connector board and reconnect to them in 5 seconds. My first version of ~100 kits have sold out and I just rolled out a new version of the breakout board for phi-connect. Now it has 5V and GND strips, better suited as a switchboard inside a project box now.

Some pictures:

You set up connections on your breadboard and keep the breakout board with the connections. You can connect to the LCD by inserting the ribbon cable into the breakout board's connection




I'm selling these on inmojo.com

http://www.inmojo.com/store/liudr-arduino-and-physics-gadgets/item/phi-connect-arduino-cable-management/
Logged


Pages: [1]   Go Up
Jump to: