Go Down

Topic: Reporgramming sparkfun openlog (Read 8 times) previous topic - next topic

jumpjack


Quote
Remember, if you get OpenLog stuck into an unknown baud rate, there is a safety mechanism built-in. Tie the RX pin to ground and power up OpenLog. You should see the LEDs blink back and forth for 2 seconds, then blink in unison. Now power down OpenLog and remove the RX/GND jumper. OpenLog is now reset to 9600bps with an escape character of 'ctrl+z' pressed three consecutive times.


https://github.com/sparkfun/OpenLog/wiki/Command-Set

Thanks, but the config fils lets me think it's already configured at 9600 bps.

jumpjack

So no news from anybody?
Tips about the "led error code"?
Explanations for empty files?

madd0c

I also would like to see more information from anyone who has sucessfully used OpenLog as a stand alone logging device. I am having significant issues using a seperate RTC(SPI) and Openlog to try to make a standalone logger capable of timestamping.
There is very little informtation or examples (any?) of a modified firmware for openlog.

I know this thread is 7 months old with no activity, but hopefully someone will see this.

jumpjack


I also would like to see more information from anyone who has sucessfully used OpenLog

I switched to PIC32 Pinguino Micro: https://www.olimex.com/Products/Duino/PIC32/PIC32-PINGUINO-MICRO/

madd0c

Sadly to large a form factor for my needs. I appreciate the information, I do hope someone who has been able to actually get a moddded OpenLog working will chime in.
I just would like to see some examples, especially of multiple SPI devices.

Thanks in advance

Go Up