Who has the Slic3r config settings for a Arduino Materia 101 Kit - Slicer ini

Hardware Materia 101
1

Hi,

I received my 101 Kit earlier this week. After some hours I was able to make it work. While reading through the manual (http://arduino.cc/en/uploads/Main/Materia101_User_Manual_EN_rev4.pdf) I found at page 25 that '.... In order to simplify the process, these are made available on the arduino web page.'

So far I wasn't able to find this config file at the Arduino web site.
If any has this file (there was no software in my Materia 101 kit), I would appriciate it very much to receive this config file... or a dump of the settings.

Regards,

Bas.
Netherlands.

2

Couldn't find it either but found two sites, possibly interesting (maybe to contact them)

This latter is completely new to me....

3

bingo?

4

Hi Rob,

That was exactly what I was looking for.
Thanks.

Bas.

5

Thank you Rob :slight_smile:

I also just updated the sticky with these settings.

6

you better call it MATERIA-FAQ I think, in the most fora "read me first" is interpreted as "skip this" :wink:

and formulate short questions (bold) with a short answer or a link to an answer or a "don't know"