Hello, I'm a newbie to this
I have been developing a device, the electronics are all tested, power supplies regulators, micro controller picked, and design has been fixed.
I am struggling with the software, the base entry level device consists of :-
Transmitter - analogue input (joystick) to ATMega or stm32 later. Output to LoRa transmitter.
Receiver - LoRa input to ATMega outputting a fixed frequency pwm - pulse width of a certain duty cycle 50% / 80% & 20% duty cycle as designated by the joystick.
It's like running a remote servo, but this is going in a different direction to that.
I will pay if someone isn't willing to write the code.
Regards, mark