In fact most of these libraries will make some form of diagnostic report on the Serial Terminal. (you need to connect MISO line to #12. you do not need the 4050)
@Atomic_SheepHave you identified pin 1 correctly and plugged the 4050 in the correct way around?
Is the backlight LED working? If it is, you should see some white light leaking out around the edges of the display.
#define TFT_RST 8#define TFT_DC 9#define TFT_CS 10ILI9341_due tft = ILI9341_due(TFT_CS, TFT_DC, TFT_RST);
... and on the side for the SD reader?
DC Current for 3.3V Pin 50 mA
Hy boys!I bought a cheap 3.2" tft display from china, but the pin outs is not clever. Can you send me a workable wiring for this pin outs? I have an Arduino Uno. The display contain ILI9341 ic, sd card reader, and resistive touch screen, but my first goal is the screen start to work.http://postimg.org/image/awbh9l5v5/I attached a picture from modul's pinout.Thanks!Tibor
Please enter a valid email to subscribe
We need to confirm your email address.
To complete the subscription, please click the link in the
email we just sent you.
Thank you for subscribing!
via Egeo 16