I got a Thermal Printer (XP-N160II), Ethernet interface. I print a selftest page by holding "Feed" button 2 seconds after power on the device.
Here is the key item was printed:
- Version: 2.5AT
- Speed: 160mm/s
- Interface Ethernet
- Ethernet ID: 00-DF-93-66-71-3B
- IP Address: 192.168.1.145
- Netmask: 255.255.255.0
- NetGateway: 192.168.1.1
- DHCP: Disable
- Default Codepage: Page0
- Chinese Char: Yes
Question:
- Is it possible using "ENC28J60 Ethernet module" control by Arduino ??
- Is it possible using to print an image / logo ?
- Is it possible print any document (Such as webpage, PDFs, etc) by MacOS?
Thank you.