Hey. Try it , type in the identification of the display screen " ILI9327 " Please tell if something moved . I have the same display and I ran it a week.
I spent over a week from morning to evening on it.
I will try to write in the evening, when I'm at home. The file had in the cloud.
Also, I was happy when I saw how it works.
That's how it works. This is my setup myTouch(6,5,4,3,2); . Top calibrate the screen example Utouch .
// UTouch_Calibration
// Copyright (C)2015 Rinky-Dink Electronics, Henning Karlsen. All right reserved
// web: http://www.RinkyDinkElectronics.com/
//
// This program can be used to calibrate the touchscreen
// of the display modules.
// This program requires the UTFT library and a touch
// screen module that is compatible with UTFT.
//
// It is assumed that the display module is connected to an
// appropriate shield or that you know how to change the pin
// numbers in the setup.
//
// Instructions will be given on the display.
//
And the most important. After downloading the program for me I have to reboot the system by disconnecting the USB cable. During calibration, follow the instructions on the screen.
Ok touchscreen now also works.
Especially removing the USB cable was a good tip, I would never have tried that.
Everything works fine now, you made my day
This is my first time trying a TFT display. I have the same problem as luxxtek above. If I use ILI9327, everything is shifted to the left. I also replaced the source file with what turla2 posted. I must be missing something, as the display is still shifted to the left using ILI9327. What control chip should I be using with turla2 source code? I'm a bit lost on this one -
Thank you very much.
Can you explain what you changed to the UTFT.cpp?
I got my display to work based on what you did. However, I can't seem to fix my screen being shifted to the left. I downloaded the .cpp file. I put it in the folder at C:/Arduino/libraries/UTFT. I replaced the existing file with it. I saved the sketch and shut down the program. I restarted it and reuploaded the sketch, but it is still shifted. Was the file supposed to go somewhere else?
Muchas, muchas gracias, teniendo este tipo de ayudas todo es mas facil y mas cuando se trata de pequeños "trucos" como el de desconectar y conectar para que funcione el programa de calibracion.
#turla2 thanks for your shared file UTFT.cpp, It works.
I wrong way to copy to the path, it have the path in :
C:\Program Files (x86)\Arduino\libraries\TFT\UTFT
and
C:\Users\ReedNoel\Documents\Arduino\libraries\UTFT
turla2:
That's how it works. This is my setup myTouch(6,5,4,3,2); . Top calibrate the screen example Utouch .
....
And the most important. After downloading the program for me I have to reboot the system by disconnecting the USB cable. During calibration, follow the instructions on the screen.
and I'm got error:
...
cc1plus.exe: out of memory allocating 1677721600 bytes
exit status 1
Error of compilation for board Arduino/Genuino Mega or Mega 2560.
...