I'm new to Arduino and was trying to use a stepper with the EasyDriver, Im using a code i found here http://www.danielschweinert.com/resources/BLOG/stepperSingleChannel03.pde . The problem is whenever i connect the EasyDrive GND to the UNO GND the L-LED goes off, i'm very poor in programming and ther…

Help needed Arduino Uno R3

Using Arduino Motors, Mechanics, Power and CNC

LarryD January 23, 2013, 11:28pm 5

Don't be upset, but re-check YOUR wiring, is it the same as this diagram?
Is your battery fully charged?
If you disconnect the motor does the sketch run OK?

Topic		Replies	Views
Easy Driver + Stepper; no result Motors, Mechanics, Power and CNC	14	3946	May 6, 2021
EasyDriver + Stepper motor + Arduino = nothing? Motors, Mechanics, Power and CNC	19	2692	May 6, 2021
Stepper motors not responding to arduino UNO!! Motors, Mechanics, Power and CNC	16	4141	May 6, 2021
EasyDriver v4.3 and sparkfun Stepper motor woes Motors, Mechanics, Power and CNC	24	12176	May 6, 2021
Stepper motor stopped responding when it used to work fine Motors, Mechanics, Power and CNC	26	6787	May 6, 2021

Help needed Arduino Uno R3

Related Topics