JonMiles:
Hi All,I am having real problems access the AT commands.
I have the following set up between a nano and the ESP-8266:
GND------->GND
VCC-------->+3.3v
CH_PD---->+3.3v
TX--------->RX
RX--------->txI am using the flowing code as a serial through:
#include <SoftwareSerial.h>
SoftwareSerial softSerial(2, 3); // RX, TX
void setup()
{
uint32_t baud = 9600;
Serial.begin(baud);
softSerial.begin(baud);
Serial.print("SETUP!! @");
Serial.println(baud);
}
void loop()
{
while(softSerial.available() > 0)
{
char a = softSerial.read();
if(a == '\0')
continue;
if(a != '\r' && a != '\n' && (a < 32))
continue;
Serial.print(a);
}
while(Serial.available() > 0)
{
char a = Serial.read();
Serial.write(a);
softSerial.write(a);
}
}
When i send AT the blue led flashes once very quickly on the ESP-8266 but i get no response back. I have tried various baud rates but to no avail. I have been searching for day on the web, but to no avail, anyone see what I am missing? thanks in advance
Start your own thread so that your problem will get the attention it needs.
You shouldn't hijack someone else's thread.