martin_bg:
I like the box, can you say a few words on how you made it?
Ah yes,
The box was originally a '2 Port Data Switch Box for Parallel Printer Ports'. Here is what they look like.
After being gutted, I marked a spot for the LCD and then spent some time with my Dremel followed by some careful filing. I then drilled some simple holes for the LEDs and switch. The SD card slot was a later edition, that was just some basic Dremel work too. As for the rear face, the original holes where the parallel ports were fitted were used to my advantage and some minor cuts were made to easily fit in the Arduino and shield. After all holes were cut and drilled, I used some 150 grit sand paper to remove the yellow-ish oxidized paint and make the proper brushed texture. Also, the rings around the LEDs are some fancy washers things I had.
As for the inside, its mostly held in place with plastic standoffs and glue.