I've just got an Atmel ICE and Atmel Studio 7.
Using the AVR interface on the ICE and the 6 pin SPI connector on an Arduino I've connected the two together.
The Uno has the Blink program installed and is powered by a separate 9V DC adaptor.
The program works correctly on the Uno.
Looking on the net for advice I came across an article on using the ICE with an SPI interface.
( http://www.crash-bang.com/debug-atmel-ice/ )
From my understanding of this the SPI needs to be setup as a debugWIRE interface by enabling a fuse on the target 328.
The article explains how to do this using Atmel Studio 7 but the process fails and generates a message;-
"Failed to enable DW; Failed to enter programming mode. ispEnterProgMode; Error status received: Got 0xc0, expected 0x00 (Command has failed to execute on this tool) "
During the process I was asked to cycle the power on the Uno and "click OK " after I had done it.
I did this but ended up with the above error.
Does anyone have any bright ideas.
I seem to be stuck with the interface remaining in ISP mode.
Any help would be much appreciated.
Regards
PJW863123