cparrish60:
My 1300 would join with the Multitech Conduit gateway, but then it would fail. I switched to "public' lorawan and it worked.
I was able to get it to work when I did this. However, sometimes when I try and join the network it times out. I've changed my setup() code to continuously retry until it eventually does join the network. Sometimes this can take a very long time.
My assumption is that the Murata module is attempting to join on one of the uplink channels that my gateway is not set up to listen on. Is there any way to configure the Murata module to only use one sub band?
Does anyone have good documentation of what the AT commands actually are for the Murata module?