I guess Im not clear on what an electrical schematic is? lol
If I remember correctly..
after tracking down the part numbers..and a vendor.. i got them from here:
(Chinese site translated)
I didnt see any spec sheet/.pdf...etc. some abrupt 'English' comments
but maybe these will help you, help me? LOL
http://www.mecquartz.com/image/datasheet/Shake%20Switch/SW-200.pdf
http://www.mecquartz.com/image/datasheet/Shake%20Switch/SW-200D.pdf
it seems like one side might be ON and the other OFF... but Im still curious as to how other 'toys' utilize it (especially NOT to trigger on a simple 'tilt')...
lol
I made a crude/simple 'demo' board with my 3 sensors on it
2 x ballbearing (swing) sensors
1 x nail & spring (clash) sensor
I have what I 'hope' is a correct and acceptable approach to using an external interrupt w/ a bit of a debounce routine in it to stop extra/false 'positives'...for the CLASH (nail & spring) sensor..
but need advice/help on working with these ball bearing types.
for testing.. I have just been taking each lead
an putting one in pin2 and the other to GND..
Thanks for any help/ideas.