atrakonline:
Hi
I met this problem too .
For solving this problem , I increase the time of board's Reset .
I used a 10K resistor and a 100uf capacitor in series and connect common point of them to RESET pin of board. also 1 pin of 10K to 3.3v and minus pin of capacitor to GNDThe Problem solved .
Thanks
This was the simplest way to fix this. Even using only the capacitor between reset and ground worked. Before doing this I tried to flash my due without success (it kept displaying verification errors) and my Due clone doesn't even have the T3 mofset to solder the resistor on...
And yes, I know the problem is old but it persists.