Make your own crossover component, see images: #1 cut 1 more piece of Nylon/Kapton tape than the number of wires involved. (I use uninsulated 30AWG wire wrap wire) #2 layout the first wire to lead spacing needed #3 cover the first wire with a piece of tape with the carrier removed #4 repeat wit…

Crossover component

Henry_Best August 24, 2014, 2:05am 2

You're for it now! Your fingerprint is on the internet

Topic		Replies	Views
DIY jumper wires Interfacing	9	8522	May 6, 2021
PCB Project Guidance	4	973	May 5, 2021
How to solder on a perfboard. General Electronics	14	27381	May 6, 2021
Homemade Double Layer PCB General Electronics	10	3083	May 6, 2021
Single sided PCB - joining up ground plane "islands" - best practice? General Electronics	10	4995	May 6, 2021