Hi all
im having a problem in the mood cue projecti in the starter kit
i 'am 100% sure the at the code dont have errors and it is working properly i believe that my problem is in the wires or the place of the components on the board
It seems that you have pin 9 connected to the power line (red) on your Servo, instead of connecting it to the control line (white). They are just backwards--switch those two connections and you should be fine.
thanks fraizor for posting the picture of your circuit! I realized my analog pin connection to the middle pin of the pot was not connected in the right spot. works great now. thanks!
The illustration figure of the 3 servo wires on the text book might cause confusion.
The combination of the physical servo connector is a little bit different.
The "red" and "black" wires are not next to each other. There is a "white" wire between them.
So it will be working if you figure this out.
Cheers!!