Best approach to use this type of 'sensor/switch'?

I guess Im not clear on what an electrical schematic is? lol

If I remember correctly..

after tracking down the part numbers..and a vendor.. i got them from here:

http://translate.google.com/translate?hl=en&sl=zh-CN&u=http://www.blswitch.com/products_show_456.html&ei=St01TNzNMoL6lwez3eDUBw&sa=X&oi=translate&ct=result&resnum=9&ved=0CDwQ7gEwCA&prev=/search%3Fq%3DSW-200D%26hl%3Den%26safe%3Dactive

(Chinese site translated)

I didnt see any spec sheet/.pdf...etc. some abrupt 'English' comments

640×650 78 KB

but maybe these will help you, help me? LOL

http://www.mecquartz.com/image/datasheet/Shake%20Switch/SW-200.pdf

http://www.mecquartz.com/image/datasheet/Shake%20Switch/SW-200D.pdf

it seems like one side might be ON and the other OFF... but Im still curious as to how other 'toys' utilize it (especially NOT to trigger on a simple 'tilt')...

lol

I made a crude/simple 'demo' board with my 3 sensors on it

2 x ballbearing (swing) sensors
1 x nail & spring (clash) sensor

I have what I 'hope' is a correct and acceptable approach to using an external interrupt w/ a bit of a debounce routine in it to stop extra/false 'positives'...for the CLASH (nail & spring) sensor..

but need advice/help on working with these ball bearing types.

for testing.. I have just been taking each lead

an putting one in pin2 and the other to GND..

Thanks for any help/ideas.