hello
I tested the tmp36 and I think I will not use again! the tmp36 is too sensitive to electrostatic waves. the only way I managed it by adding a 0.1 uf ceramic capacitor for the values ??are more stable on the breadboard. but when you make a perforated plate or you use more than one tmp36 or otherwise in a surrounding with lots of electrostatic waves (film studio, or near a motor). this is not the same games. the first tmp36 influences the values ??of the other and so on. Environmental electrostatic waves distort the sensor values
The slightest change of voltage (power outage, run down, connection error etc.). Sensor burns. must be experienced in electronics, it's really not recommended to beginners! it should be noted that on this forum there are requests for help almost every 2 days for tmp36. must deduce something. I finally used a thermistor (variable resistor heat) and everything is settled.
emmanuelle