trying to use an arduino-uno to move Hover Board motors_Need Help please

I am making a robotic T-Shirt cannon, and I am wanting to use the internals of a hover board, mainly the wheels, and the logic board. I am trying to figure out how the Gyros are communicating to the logic board. I am wanting to mimic the signals with the arduino, I am just wanting to at least make the motors move clock wise, and counter clock wise, any help would be greatly appreciated :slight_smile:

Are you looking to have it self balance?
Or just using it to move your vehicle?

If you are just using it to propel an otherwise stable vehicle, I would skip their electronics entirely and go with a known motor driver.

I am just wanting it to propel, and i was wanting to see if i could just use the ESC motor drivers built into the board.

I don't have one of those logic boards in front of me.
Can you snap some pictures of it and post them here?

Yes, sorry for the late reply too.

my computer is not letting me upload the image, but i can get you the board number if that helps.

ROHS TT-SCCO2B

that is the number in the board if you want to look it up

Very little info on the inter-webs for this.
Pictures from a few ebay auctions.
I can't help but think you would be better off choosing an appropriate motor driver and using that.