I am running BOTH an Arduino IDE and AS6 IDE on a Windows XP platform. I can upload sketches from Arduino to my Atmega2560, but can’t load same sketch from AS6.
The programmer listed for Arduino is USBasp.
I have tried three avrdude command lines in AS6. Not one works.
I have listed the setup and results below:
Using: id arduino
…\avrdude.conf -v -v -p m2560 -c arduino -P COM4 -b115200 -D -Uflash:w:"$(ProjectDir)Debug$(ItemFileName).hex":i
result:
Using Port : COM4
Using Programmer : arduino
Overriding Baud Rate : 115200
avrdude.exe: stk500_getsync(): not in sync: resp=0x00
Using: programmer id usbasp
…\ avrdude.conf -v -v -p m2560 -c usbasp -P COM4 -b115200 -D -Uflash:w:"$(ProjectDir)Debug$(ItemFileName).hex":i
result:
Using Port : COM4
Using Programmer : usbasp
Overriding Baud Rate : 115200
avrdude.exe: error: could not find USB device "USBasp" with vid=0x16c0 pid=0x5dc
Using: programmer id stk500v2
…\ avrdude.conf -v -v -p m2560 -c stk500v2 -P COM4 -b115200 -D -Uflash:w:"$(ProjectDir)Debug$(ItemFileName).hex":i
result:
Using Port : COM4
Using Programmer : stk500v2
Overriding Baud Rate : 115200
avrdude.exe: stk500v2_ReceiveMessage(): timeout