using pullstime

Using Arduino Programming Questions
40

I would either do

Serial.print(myPulsetime = (mypulseTime + pulseIncrement));

or Serial.print(1000)

However, I kind of got over that version so what do you think about this code? what should I connect the A2 to ground/ 5 volts? It wasn't written by me I just edited it a bit.thanks for the help, man I really appreciate it

#include <Servo.h>
Servo m1;
const byte buttonPin = A2;
const int ledPin = 9;

const int PulseTimeBase = 1000;
const int PulseTimeIncrement = 250;
int myPulseTime = PulseTimeBase;


int buttonPushCounter = 0;   // counter for the number of button presses
int buttonState = 0;  
int LastbuttonSate = 0;// current state of the button

void setup()
{
  // initialize the button pin as a input:
  pinMode(buttonPin, INPUT);
  // initialize the LED as an output:
  pinMode(ledPin, OUTPUT);
  // initialize serial communication:
  Serial.begin(9600);

  m1.attach(9);
}

void loop()
{
  buttonState = digitalRead(buttonPin);

  switch (buttonPushCounter)
  {
    case 1:  // 1/4 speed and reset the push counter
      buttonPushCounter = 0;
      myPulseTime = PulseTimeBase + PulseTimeIncrement;
      break;
    
     case 2:  // First push: 1/2 speed
      myPulseTime = PulseTimeBase + PulseTimeIncrement + PulseTimeIncrement;
      break;

    case 3: // Second push: 3/4 speed
      myPulseTime = PulseTimeBase + PulseTimeIncrement + PulseTimeIncrement + PulseTimeIncrement;
      break;

    case 4: // Third push: Full speed
      myPulseTime = PulseTimeBase + PulseTimeIncrement + PulseTimeIncrement + PulseTimeIncrement + PulseTimeIncrement;
      break;


    default:  // reset  and reset the push counter
      buttonPushCounter = 0;
      myPulseTime = PulseTimeBase;
      break;




  }
  m1.writeMicroseconds(myPulseTime );
}