Hello!
I have a quick question regarding to waveshare module from the topic. I have already checked communication between arduino and waveshare module and everything seems to work fine, but to startup module for the first time you have to pull down power button for few seconds. Another way to boot module is to use some pinout. As i have checked you have to use analog pin A5 from arduino uno. How to do that? I tried to set A5 pin as below and it doesn't work. Here is further documentation of waveshare module:
pinouts: https://www.waveshare.com/w/upload/1/10/GSM-GPRS-GPS-Shield-B-Schematic.pdf
documentation: https://www.waveshare.com/w/upload/e/e8/SIM808_Hardware_Design_V1.02.pdf (page 24)
First in "setup" section i have declared pin: pinMode(A5,OUTPUT);
and then in loop:
analogWrite(A5,HIGH);
delay(3500);
analogWrite(A5,LOW);
Thank you in advance for any response.