I just got a 6 x 10 each pack of colored clear LEDs from CLEDs and was wanting to test them for color and brightness. I loaded the blink sketch and tied GND and Pin 13 to the power rails on my breadboard. I stuck in a red LED and it flashed on and off and was very bright. I then also stuck in a blu…

LED cutoff point?

rickso234 January 5, 2013, 3:12pm 10

Seems some magis smoke came out of the limiting resistor too! Must have had "limited" capability.

Topic		Replies	Views
2 RGB LEDs in Parallel HELP Project Guidance	4	2672	May 5, 2021
Blue led issue General Electronics	11	3092	May 6, 2021
Low voltage 0.2V LEDs and Multiplexing	16	5579	May 6, 2021
LED resistences in the kit The Arduino Starter Kit	2	5901	May 6, 2021
Bright LED's Troubleshooting	10	2608	May 6, 2021