Hello, I am having a difficult time getting the OTA flashing operation to work. I followed the OTA example and it appears to connect via the Network port and accepts the command to load a new program. However it fails the flash operation. Is there a step I have missed - or how can I correct this…

MKR1000 - OTA flashing does not work

ela55 February 12, 2019, 3:18am 4

Thanks again marcomss,
It was the password as you said.
I had tried for too long the other night and revisited after your reply.

Working now
Thanks

Topic		Replies	Views
Update sketch OTA on Arduino MKR1000 Project Guidance	2	807	May 5, 2021
OTA on Wifi1010 = board stuck at boot? (no longer functioning?) MKRWIFI1010	16	2276	May 7, 2021
MKR1000 Doesn't Run "Blink" Sketch IDE 1.x	3	1011	May 5, 2021
Serial uart commuication problem MKR1000	2	1295	May 7, 2021
MKR1000 setup issues, 'programmer not responding' Sketches not working MKR1000	3	1954	May 7, 2021