sp_mike:
I was just coming back to the forum to clarify what I actually meant. These were just the figures for what I was using in my environment, but that you need to use your own figures. You have no doubt tried my values by now anyway.
Thank you sp_mike. It's good to know that my code sketch isn't too far off from yours.
I think I'm going to try a few more things as well.
- Confirm that the chipset in the remote is on the supported device list, GitHub - sui77/rc-switch: Arduino lib to operate 433/315Mhz devices like power outlet sockets.
- Try changing the protocol to 1 (instead of 2) and then setting the pulse length afterwards
- Try sending the signal using a binary code
- Try sending the signal using a tri-state code