Hi all,
I'm trying to use my micro:bit with the Arduino IDE. So far - I have the IDE having the micro:bit installed in tools. I plug the device in and it comes in at COM17 (note - it doesn't say anything after it). Softdevice set to "S110". Programmer is "CMSIS-DAP" (I've tried several with the same outcome). I compile some software ok. I then flash the software (it's going somewhere - the led on the device flashes as it goes in). However, it's not successful - I get the errors:
c:/users/jones/appdata/local/arduino15/packages/sandeepmistry/tools/gcc-arm-none-eabi/5_2-2015q4/bin/../lib/gcc/arm-none-eabi/5.2.1/../../../../arm-none-eabi/bin/ld.exe: warning: changing start of section .heap by 4 bytes
c:/users/jones/appdata/local/arduino15/packages/sandeepmistry/tools/gcc-arm-none-eabi/5_2-2015q4/bin/../lib/gcc/arm-none-eabi/5.2.1/../../../../arm-none-eabi/bin/ld.exe: warning: changing start of section .stack_dummy by 4 bytes
c:/users/jones/appdata/local/arduino15/packages/sandeepmistry/tools/gcc-arm-none-eabi/5_2-2015q4/bin/../lib/gcc/arm-none-eabi/5.2.1/../../../../arm-none-eabi/bin/ld.exe: warning: changing start of section .heap by 4 bytes
c:/users/jones/appdata/local/arduino15/packages/sandeepmistry/tools/gcc-arm-none-eabi/5_2-2015q4/bin/../lib/gcc/arm-none-eabi/5.2.1/../../../../arm-none-eabi/bin/ld.exe: warning: changing start of section .stack_dummy by 4 bytes
c:/users/jones/appdata/local/arduino15/packages/sandeepmistry/tools/gcc-arm-none-eabi/5_2-2015q4/bin/../lib/gcc/arm-none-eabi/5.2.1/../../../../arm-none-eabi/bin/ld.exe: warning: changing start of section .heap by 4 bytes
c:/users/jones/appdata/local/arduino15/packages/sandeepmistry/tools/gcc-arm-none-eabi/5_2-2015q4/bin/../lib/gcc/arm-none-eabi/5.2.1/../../../../arm-none-eabi/bin/ld.exe: warning: changing start of section .stack_dummy by 4 bytes
Sketch uses 2772 bytes (1%) of program storage space. Maximum is 151552 bytes.
Open On-Chip Debugger 0.10.0-dev-00254-g696fc0a (2016-04-10-10:13)
Licensed under GNU GPL v2
For bug reports, read
** OpenOCD: Bug Reporting**
debug_level: 0
swd
cortex_m reset_config sysresetreq
adapter speed: 1000 kHz
nrf51.cpu: target state: halted
target halted due to debug-request, current mode: Thread
xPSR: 0xc1000000 pc: 0x00018e20 msp: 0x20004000
** Programming Started **
auto erase enabled
wrote 3072 bytes from file C:\Users\Jones\AppData\Local\Temp\arduino_build_255929/sketch_jun11b.ino.hex in 0.499201s (6.010 KiB/s)
** Programming Finished **
** Verify Started **
verified 2892 bytes in 0.140401s (20.115 KiB/s)
** Verified OK **
** Resetting Target **
shutdown command invoked
And nothing is working. I'd really appreciate some help on this