Hello All, i have an issue with a new feature i'm adding to an existing product.
basically i have a MIDI controller that i want to be able to "Teach" new commands. the project that this is for already exists and so my pin configuration is set. in order to teach a new command i need to make the TX pin a software serial RX pin. this works fine on my Arduino but when i tried it on a 328 without the boot loader something went wrong and the command read is not the one sent. i think this is either due to a bit being missed or clocking issues. i really don't want to have to use the boot loader, can anyone think of what might be causing my issues. ?
Ps. sorry for not including any code. its very long and i'm not sure what is relevant.