Good morning everybody,
Without any modification from the original WiFiNINA firmware updater, I got the error message:
"SerialUSB was not declared in this scope"
Hw and sw details:
Arduino:1.8.9 (Windows 7), Scheda:"Arduino Uno WiFi Rev2, ATMEGA328"
WiFiNINA firmware check: Firmware version installed: 1.0.0
Thanks in advance for any actionable help and suggestion.
Andrea
following detail from the error message and related code, I think you should know pretty well
C:\Users\ThinkPad\Documents\Arduino\libraries\WiFiNINA\examples\Tools\WiFiNINAFirmwareUpdater\WiFiNINAFirmwareUpdater.ino: In function 'void setup()':
WiFiNINAFirmwareUpdater:25:3: error: 'SerialUSB' was not declared in this scope
/*
WiFiNINAFirmwareUpdater - Firmware Updater for the
Arduino MKR WiFi 1010, Arduino MKR Vidor 4000, and Arduino UNO WiFi Rev.2.
Copyright (c) 2018 Arduino SA. All rights reserved.
This library is free software; you can redistribute it and/or
modify it under the terms of the GNU Lesser General Public
License as published by the Free Software Foundation; either
version 2.1 of the License, or (at your option) any later version.
This library is distributed in the hope that it will be useful,
but WITHOUT ANY WARRANTY; without even the implied warranty of
MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the GNU
Lesser General Public License for more details.
You should have received a copy of the GNU Lesser General Public
License along with this library; if not, write to the Free Software
Foundation, Inc., 51 Franklin St, Fifth Floor, Boston, MA 02110-1301 USA
*/
unsigned long baud = 115200;
void setup() {
SerialUSB.begin(baud);
SerialNina.begin(baud);
pinMode(NINA_GPIO0, OUTPUT);
pinMode(NINA_RESETN, OUTPUT);
}
void loop() {
digitalWrite(NINA_RESETN, SerialUSB.rts());
digitalWrite(NINA_GPIO0, (SerialUSB.dtr() == 0) ? HIGH : LOW);
while (SerialUSB.available()) {
uint8_t c = SerialUSB.read();
SerialNina.write(c);
}
while (SerialNina.available()) {
uint8_t c = SerialNina.read();
SerialUSB.write(c);
}
// check if the USB virtual serial wants a new baud rate
if (SerialUSB.baud() != baud) {
baud = SerialUSB.baud();
SerialNina.begin(baud);
}
}