Is there anyone who tried to minimize the power consumption of the SAMD21 based arduinos? I made it go in deep sleep, and I disable every possible RUNSTDBY bits I could find, but it still consumes 3 milliamps based on my multimeter while sleeping. That is a really high value, is it not? An other interesting detail is, that if I instert wire.begin in the startup code, the power consumtion drops (1,7mA).
The spec says it has a 2db but then it also says you must use an external antenna.
Over short range 2db will be fine.
Do I actually HAVE to attach an external?
Thanks
We are slightly OT.
There is no PCB antenna on board, so you need something external.
However, I received the MKR WAN already with an external antenna, it was in the package (I think it refers to it -a dipole). With the original antenna I was able to reach a gateway 27km far, so not bad at all (I suppose because the gateway has an excellent antenna).
@NeilE I have exactly the same current 1.16mA. I also suspect the Murata firmware is not sleeping the module. Other people using the Murata module with other firmware have reported sleep currents of 2uA for the module.
For others following this thread or the other threads on this forum related to deep sleep power consumption for the MKRWAN1300, there is a hardware problem with the current version of the MKRWAN1300 that prevents it from achieving a sleep current below 1.15mA. Arduino has confirmed there will be a board revision that will correct the problem.
sslupsky:
For others following this thread or the other threads on this forum related to deep sleep power consumption for the MKRWAN1300, there is a hardware problem with the current version of the MKRWAN1300 that prevents it from achieving a sleep current below 1.15mA. Arduino has confirmed there will be a board revision that will correct the problem.
Thanks for the update, looking forward to the hardware revision.
Also, I wonder where I can get the latest update on this issue.
I also have the same deep sleep current issue. I wonder if you fix it out?
Also, when I put deep sleep code in the loop and use RTC to wake it up. The SAMD21 chip only wakes up for 1 time, then never wake up by RTC. Do you know what cause that?
I am currently working on the same problem, using the MKR GSM 1400. I also tried to include your code, but I can't get lower than 11mA... Can you maybe share your complete code with me? It is really frustrating to not get lower...
Since January 28th 2019, it looks like -at least- Eagle' schematic & Board have been corrected in regards of VDD_TCX0 and VBus. But it still reads the same name and release # MKRWANV1_1....
Do not know for the real board...
I am waiting for many months for updates on the new revised board before buying it. How long do we really have to wait for the issue to be fixed and the new board be released ?