I'm using an Arduino Nano to control the base of a 2N2222 to drive a 200 mA motor.
The power supply at the collecter is 3V 1A max so it is sufficient.
When I connect the 5v pin to the base, it runs amazingly, however, when I connect to
pin 9 on HIGH, it barely moves. I used a multimeter to check the current and I see that
the 5V pin allows about 8 mA to the base, while pin 9 on HIGH allows only 1 mA.
Why is this? How can I use pin 9 for around 10mA?
Btw, even the other pins output less current. Only 5v outputs sufficient current.