Hi,
I am currently assembling the kit, but I'm not too sure where/how the thermistor goes?
Is it just connected to the ramps shield, or do I need to attach it to the hot end in some way?
Also, do I have to solder it on, or are there connectors?
Last but not least, where do I need to use the Kapton tape provided?
I wondered the same thing when I assembled my printer. I discovered there is another thermistor and the kapton tape is already used in pre-assembled the hot-end, so I think it is only a replacement.
I saw how to assembly the hot-end in Kiwi3D assembly manual (you can see how the thermistor is used)