[SOLVED] MKR Ethernet TCP Connection with Horsepower Sensor

Using Arduino Networking, Protocols, and Devices
5

cjtate14:
@Juraj I’m trying the connection over direct Ethernet cable between the MP8000 and MKR ETH shield. Picture of setup attached.

@gbafamily that was my initial thought, too. I plugged my laptop into the MKR ETH shield to find its IP address and then did the same for the MP8000. Using those IP Addresses made no difference.

for direct connection:

  1. use crossed cable
  2. you are responsible to set the IP addresses in this network with two devices