Motor Control...

Hi Folks, I have two motor controlers and cannot make either of them work... :roll_eyes:

Truth is my control requirement is pretty simple. I want to control two motors... I want to read an analog singnal voltage (0-5V) and use that singnal to control two DC motors from 0-100% duty using PWM...

The devices I have seem to have more capabilities then I need ( stepper motor , reverse, etc..)

Is there examples both in code and in how I'm supposed to wire these devices to drive two motors using PWM based on an analog input?

Any help is greatly appreciated...

Here are the motor controllers...

http://www.emartee.com/product/41445/Wrobot%20L298N%20Motor%20Driver%20Shield%20V1.0

Tim

Hi Folks, I have two motor controlers and cannot make either of them work...

So, what problem are you having with the forum?

If you have a hardware or software problem, there are much more appropriate places to post your issue.

Oops... Sorry, I'l repost in a more approprate place... Thanks