I've had the same problem as mech_1794 and deterr. If I set my baselineTemp to something much higher, say 70 C, then the temperature sensor works fine (5-10 degree increases in temperature in the monitor when I touch the sensor, and then back down when I remove my hand) but none of the LEDs get activated.
Alternatively, if I set the system to run and touch the TMP36 so that it spikes up and registers temperatures around 70 C, and THEN pull out the LEDs one by one, I see the temperature sensor drop back down 10-20 degrees at a time until it's back in the normal range.
Could there by an ungrounded signal or something causing some interference? Would another resistor connected somehow to the temperature sensor pull down any stray voltage?