Arduino Forum

Using Arduino => Installation & Troubleshooting => Topic started by: Moutfort on May 22, 2016, 03:39 pm

Title: Cannot up load sketch
Post by: Moutfort on May 22, 2016, 03:39 pm
Cannot get board to load a sketch, tries 10 times and gives message  "not in sync. res=0xbd

Have gone through all trouble shooting suggestions, and have reloaded IDE but to no avail

T Evans Luxembourg
Title: Re: Cannot up load sketch
Post by: spycatcher2k on May 22, 2016, 04:00 pm
OK- Basics please :

What board
What IDE
What operating system
Describe what you actually tried
Provide a link to where you purchased the board
Describe What you see in the device manager (Com port added when Arduino plugged in)

I know it's a lot of questions, but without this information, anything would only be guesswork.
Title: Re: Cannot up load sketch
Post by: Moutfort on May 22, 2016, 04:17 pm
Board Genuino UNO

IDE 1.69

Tried ti Load BLINK to test board

Com port 7 Confirmed as Genuino UNO

After loading ...   Not in sync: resp=0xbd

Title: Re: Cannot up load sketch
Post by: spycatcher2k on May 22, 2016, 05:20 pm
Try a different USB port ON your PC, try a different USB lead - Don't use a hub, unpowered hubs don't really work well with Arduinos.
Title: Re: Cannot up load sketch
Post by: Moutfort on May 22, 2016, 05:38 pm
Have tried USB Connection and lead. have even tried a different pc result is always bad
Title: Re: Cannot up load sketch
Post by: spycatcher2k on May 22, 2016, 05:42 pm
Then your arduino is broken - assuming you have NOTHING connected to it other than the USB lead

Return it to the authorized seller for a replacement ;)
Title: Re: Cannot up load sketch
Post by: spycatcher2k on May 23, 2016, 10:56 pm
Quote
Vid 2341 Pid 0248
Can you confirm the Pid please - thats not a Genuino Pid.