Arduino Forum

Products => Materia 101 => Topic started by: ismaelbaum on May 23, 2016, 08:43 am

Title: Jump on Y axis
Post by: ismaelbaum on May 23, 2016, 08:43 am
Hi,

I got the kit set up, all motors working, everything looks good.

BUT, when I start printing any gcode, after every (let's say around) half a layer, the extruder moves a few millimeters on the Y axis, so it prints like a ladder, which doesn't work of course.

No idea why this would happen, any clues?

Thanks
Title: Re: Jump on Y axis
Post by: dp_1 on May 25, 2016, 04:28 pm
Have you adjusted the motor currents on the drivers? The Y stepper might be losing steps.
dp_1