Arduino Forum

Using Arduino => Installation & Troubleshooting => Topic started by: Moutfort on May 23, 2016, 10:14 pm

Title: loadup sketch on to Genuino UNO
Post by: Moutfort on May 23, 2016, 10:14 pm
Problem.      Cannot load sketch to Genuino UNO Using basic sketch BLINK.

Pc details.     O/S Windows 7 Prof. 64 Bit 8Mb Ram Service pack 1

Board.          Bm Ardoino  Vid 2341 Pid 0248 SN 85438363938351410281 running 1.6.9 with ATmega 328

Information.   1. On the Pc 'Devices/Ports/Com.LPT Genuino is recgnised on COM7
                     
                    2. In Tools of IDE 1.6.9. Board is marked as Arduino/Genuino
                   
                    3.Port is confirmed COM 7 Arduino/Genuino
           
                    4. After trying 10 times to upload I receive  message as follows
 
                    Avrdude: Stk500-Getsync() attempt 10 of 10 not in sync: resp=Oxde
                    Avrdude: Stk500 -recv() programmer is not responding

Have tried many suggestion, such as Change USB cables/ ports. early versions of  IDE. a second pc running Windows 7 / home / 2 Bit.



Title: Re: loadup sketch on to Genuino UNO
Post by: spycatcher2k on May 23, 2016, 10:25 pm
I still say :

Then your arduino is broken - assuming you have NOTHING connected to it other than the USB lead

Return it to the authorized seller for a replacement ;)
Title: Re: loadup sketch on to Genuino UNO
Post by: spycatcher2k on May 23, 2016, 10:34 pm
OK - I'll bite,

Post a link to where you bought it
try the loop back test - post the outcome
Photograph the box the Arduino arrived in, and post it.
Title: Re: loadup sketch on to Genuino UNO
Post by: AWOL on May 23, 2016, 10:35 pm
Try here (http://forum.arduino.cc/index.php?topic=402207.msg2766927#msg2766927)