Arduino Forum

Using Arduino => Installation & Troubleshooting => Topic started by: James_Seeed on Jul 05, 2016, 08:47 am

Title: Arduino CAN-BUS Shield V1.2 Car Tiguan
Post by: James_Seeed on Jul 05, 2016, 08:47 am
HI, I'm trying to receive CAN data from Arduino CAN-BUS Shield V1.2 (http://www.seeed.cc/products.html?t=Arduino) my car VW Tiguan.

The massage "CAN BUS Shield init ok!" was displayed..

But I could not receive any data..



Here's my environment:

Arduino UNO R3 (http://www.seeed.cc/products.html?t=Arduino)

Seeed Studio CAN-Bus Shield v1.2 (http://www.seeed.cc/products.html?t=Arduino) (I removed the terminal resistor)

OBD-II cable(6pin, 14pin)

VW Tiguan vehicle (2015)

CAN Bus rate setting : 500Kbps

Arduino baud rate setting : 115200

(http://www.seeed.cc/upload/img/community/20160526101745-file_5.jpg)


Thank you in advance.
Title: Re: Arduino CAN-BUS Shield V1.2 Car Tiguan
Post by: nicholas7 on Sep 16, 2016, 12:21 am
I have the same issue did you solve it?
Title: Re: Arduino CAN-BUS Shield V1.2 Car Tiguan
Post by: pdavid12345 on Dec 25, 2017, 06:27 am
The Tiguan 2015 is using UDS(2009-2015) or UDS+(2015--->) protocol for communicating over can bus.
Here you can find something useful: https://github.com/openxc/uds-c