Arduino Forum

Using Arduino => General Electronics => Topic started by: maurizioarduino on May 19, 2017, 07:30 am

Title: Problems with analog port reading flame sensor and mq2
Post by: maurizioarduino on May 19, 2017, 07:30 am
Hello to all,
Are the first weapons with Arduino. I tried to put the flame detector and the Mq2 sensor (gas detector) but having followed several tutorials does not change my reading value. In the serial monitor I always get the same values. The links look just, I've tried different. I also changed board and sensor. What is wrong?
Thank you
Title: Re: Problems with analog port reading flame sensor and mq2
Post by: 6v6gt on May 19, 2017, 06:32 pm
Do you mean this ?
Grove - Gas Sensor(MQ2) (http://wiki.seeed.cc/Grove-Gas_Sensor-MQ2/)

It looks like you are using Google translate or similar and it is not very clear what you say.

This is a gas detector and there is a tutorial at the link above. Have you tried this tutorial ?